Posted by IOWA NORTHEAST on August 07, 2010 at 13:09:49 from (206.72.18.89):
In Reply to: what is it? posted by pdz180 on August 07, 2010 at 10:53:02:
I can not tell by the size, but I have one that is on legs, it is definatly used for taking steel wheels, and making cut offs for tractor rears.
If it is for tractors, you adjust the (fender to rim width) using the three --this on has one missing) little redi rod ordeals to keep the exact spacing.
They had a rod with a washer on the end that could be adjusted with a screw. You put the tip of the cutting torch in the washer, and it made a perfect circle. This would be the same size as your new cut off rubber tire rims.
I was told that when welding the spokes, you always welded everyone except the last one. You were then supposed to drink one adult beverage, and then weld the last one. Other wise the welds could break from stress.
I purchased mine for twenty five dollars, and everyone wanted to know what it was.
If you watch alot of tractors run down the road with cut offs, the rear wheels go from side to side. Not when you use this unit properly.
Years ago when used tires were needed for wagons, 16 inch tires had to be purchased new, as car tires were not usualy of that size. With this you could redo any wheel to the most popular size and use used car tires for your wagons.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Buying your first tractor: The People You Buy From - by Chris Pratt. If you are a first-time buyer, chances are that you are likely to take the word of the seller on things. This is where the problems start... You have reviewed your implement needs and determined the size of machine that will fit the bill and even made a list of the most desirable models. You checked on the availability of a 3-point hitch for the machines on the list and advertised in your local classified paper with so
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
