I would say as a rough rule of thumb once you get over 50 acres of corn silage you see guys own an older self-propelled and a lot of guys just hire it done. Most of the big dairies (several hundred animals and greater) are looking to help offset the cost of a new 6 row or bigger harvester that has a kernel processor by doing custom work. Rates run from 175 to 300 dollars per cutterhead hour and those machines can cover a lot of ground in an hour if they are not waiting for trucks. If they can get one, alot of guys figure they are ahead cost-wise if they can get the big harvester for custom. New small 2 row machines are over 30K such as NH 790 and JD 3955 w/o heads. Mower-conditioners are a little different proposition as nearly all farms seem to have one and anything smaller than the biggest seem to have a center-swing cutterbar or disc unit as opposed to a self-propelled. In New York dealers that kept several new units and a couple dozen used units for pull-type forage harvesters now maybe keep one new and a few used on the lot so that practice has lost a lot of favor in the last decade. One of my favorite things growing up was watching dad out with the 4010 diesel and 2 row out chopping corn followed by bringing it back and blowing it up a vertical stave silo. Not much of that done at least in these parts anymore. Somebody 100 miles away in any direction from me could paint a completely different picture than the one I did.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
