Posted by JDseller on July 31, 2010 at 20:26:33 from (208.126.196.117):
In Reply to: Wagon Hoist posted by Bill in IL on July 31, 2010 at 12:06:22:
Those hoists where not made for high pressure hydraulics. I blew the end out of one twenty years ago. It happens when you let it hit the end of its stroke. That little snap ring was made to hold back a system with 1500 psi or less. Your newer tractors can have up to three thousand psi. You can replace the cylinder with one that has a smaller bore and the same stroke. A tie bolt cylinder is the cheapest. Bailey Company is a good place to get cylinders too. http://baileynet.com/
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.