Posted by Leroy on July 28, 2010 at 05:30:24 from (69.88.223.179):
In Reply to: Re: roof pitch posted by Glenn F. on July 27, 2010 at 21:19:32:
No roof load ratings in my area and no building codes or permits required for farm buildings. That said in the 70's we built on the side of the barn 20' wide and had to use 22' rafters and they are 2 X 6 on 16" centers with 1 X 4 sheating spaced 8" between with steel roof and pitch if possibly at most 3-12 with no problems yet and we do get heavy snow loads, never shovel a roof, and some mighty strong winds. Few years later built shed on end of barn, 18' with 20' rafters (22' not avaible) 1/2" plywood sheating and shingles, pitch is just slightly more as top height and bottom height same, just 2' narrower and rafters holding up good. Had to replace shingles once.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
