Posted by JDseller on July 22, 2010 at 23:19:29 from (208.126.196.117):
In Reply to: manifold studs posted by Chas. Ont. on July 22, 2010 at 19:36:11:
I will second what NCwayne said. Splitting the nut is the only sure way. I have a nut splitter that works great if you have room. It has a hole in it that you place over the nut and then tighten a screw that pushes a blade into the side of the nut. The next best way it to use a acetylene torch to heat the nut red hot,fast. Propane torches heat slower and that heats the stud too. You want the nut to expand more than the nut. So you have to heat the nut fast. Then while the nut is red hot use a six point socket on it to remove it. I often have to use a metric one that is a little smaller than the English size. Those old exhaust studs and nut rust away. I also have a set of nut removers from Snap on. They are basically just a left hand internal sparling taper that bites rounded off nuts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
