Posted by Loren MN on July 16, 2010 at 08:20:53 from (64.65.174.118):
In Reply to: Re: BP oil spill posted by Fred Martin on July 16, 2010 at 07:53:34:
I suppose the pressure in the pipe needs to be looked at relative to the pressure surrounding it. If the water pressure is 5000 PSI or so surrounding it, then the differential pressure would be around 1/2 of what it would be at atmospheric pressure. Would be nice if the govt. would give us a view with our own sub cameras instead of relying only on BP's video of the well. Does anyone know whether oil is leaking at any other areas of the seafloor?
Boycotting BP at the gas pump is a waste of time. Where do they think gas from some of the other stations comes from? It all goes into the same pipe from the refinery and gets distributed under the name brands later. People don't realize how much oil is used for the production of chemicals and plastics, and that fuel is only part of where the oil ends up. If they want to boycott BP, they should also stop buying cell phones, soda bottles, and anything else made out of plastic. We mold tons of polypropylene that is made by BP Amoco Polymers.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
