I'm still not quite convinced.........every time I'm driving and I catch a whiff of a vehicle running rich, it is always some pre-1985 vehicle which likely is carburated. I'm not saying it is not possible to make it run correctly and burn a proper mixture, but it takes more time and maintenance. Yes, there are ways of mechanically fuel injecting vehicles as you say that date back to the 50's but those systems were complicated and lets face it, mechanical things need maintenance.........and often lots of it!
The equivalent mechanical system required to do all that a modern computer controlled vehicle is doing would be a) costly b) complicated c) unreliable and d) if not maintained very inefficient
If all the vehicles on the road today used strictly mechanical systems or electrical instead of computerized for fuel and ignition there would be far more breakdowns, lower fuel economy and more trips to the mechanic.
With a computer controlled fuel injection system you have eliminated 90% of moving parts associated with carburetor failure. No matter how well something is built, if it is mechanical eventually it will fail. If it is built so well that it will never fail, nobody could afford it!
Now.........having said all that, I do believe that computers in vehicles are in places where they should never be. They should never control your brakes, your throttle (just ask Toyota!) or your basic systems like lights, wipers, heating/cooling, steering, suspension, your radio and the security systems in many vehicles is way over the top! Heck, even the fuel gauge is run through the computer in my '98 Silverado...........but we won't even get into that!
So in some ways I agree, in others I really disagree.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
