|
Tractor Talk Discussion Board |
Re: 1949 Case VAC
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ERIC PITCHER on July 03, 2001 at 18:44:36 from (63.20.100.102):
In Reply to: 1949 Case VAC posted by Mike Cline on June 29, 2001 at 12:44:46:
I PUT RODS AND MAINS IN MY 51 VAC A FEW WEEKS AGO.I TORQUED IT AND IT WOULD HARDLY TURN OVER.I FOUND THE REAR MAIN CAP IS ALSO THE BACK OF THE BLOCK AND THERE IS A GASKET IN THERE THAT WILL COCK THE CAP IF YOU ARENT REALLY CAREFUL.IT WILL LOCK IT RIGHT UP.IF YOU DIDNT TOUCH THE MAINS I DONT KNOW WHAT IT COULD BE.GOOD LUCK
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
