Posted by Hendrik on June 18, 2010 at 03:07:25 from (194.53.253.51):
In Reply to: Need a 15 mm bolt posted by JBMac on June 17, 2010 at 20:14:13:
While I agree that 15 mm does not come close to any regular inch size bolt, I doubt whether your bolt is 15 mm. I am 55 years old, was born and raised on a farm and did a lot of wrenching but have yet to see a 15 mm bolt. Admittedly, I never worked on Ford tractors ;-) In my teens we still had 12, 14, and 16 mm threads, later the 14 mm was eliminated from the list of recommended sizes. Common sizes these days are 2, 3, 4, 5, 6, 8, 10, 12, 16, 20, 24, 32, 48, and 64 mm (and some smaller and larger sizes at both ends of this range...) HTH, Hendrik, The Netherlands, metric country.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
