Posted by Old Roy on June 17, 2010 at 21:24:41 from (174.130.31.130):
In Reply to: Re: James and Nancy posted by James Howell on June 17, 2010 at 08:50:52:
MY GOOD BUDDY????? !!! Thanks !!! The only reason I miss him as he wasted a good poem I still have in case he comes back.
Maybe I should have it published in the Winona News, but you are right forgiveness is the best route to go. These "drive by" comments will probably go on from strangers,but you have a lot more friends on this forum than you do enemies.
Hows the saying ? " Best to keep yer mouth shut and let folks wonder if your a fool, Than to open it and remove all doubt"
I think only fools would attack either of you so I come to your defense even though I know you are fully capable of handling it yourself. I am positively sure someone will second that.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.