Posted by PreciseFarms on June 04, 2010 at 20:19:54 from (98.159.203.240):
In Reply to: soybean population posted by J Heitkemper on June 04, 2010 at 11:02:26:
We go with 150k/acre with a planter so we get pretty close to that actual stand. That is why we went back to a planter in the mid-90s. We were running two 750 no-till drills and population and stand were never consistent enough for the expensive seed coming along. It wasnt too bad when you used to plant public varieties and could save seed each year. We are on our second Deere 15in split-row planter. Nothing will plant corn and beans more accurately and you only have one machine for all of it. In addition to the 12/23 row Deere we also have a Kinze 6/11 that is similar. It does a pretty good job but won"t plant as fast, in as hard a ground conditions, and it isn"t central fill. The split-row planter, no matter what the brand is the way to go. You get a much better stand and you know your population all the time, no matter what the seed size is, you just watch the monitor count them off for you. A good Kinze like we have sells for about 15 to 20k. The only thing ours gets used for is planting over corn now since we reduced acres about 5 years ago, but it is very handy for that, would only be better if it was integral and not drawn. Long post for an opinion, but long story short, drills are for small grains, a planter is the stuff for accurate planting.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
