Posted by JML755 on June 03, 2010 at 09:43:35 from (66.184.63.110):
In Reply to: Gulf oil well posted by Earl in Kentucky on June 03, 2010 at 06:56:57:
supergrumpy,
been watching the "live feed". Yeah, it appears the "sheared" cut is at an angle across the pipe and the back side appears to be pretty butchered up. As I was watching, they were trying to cut something off the side of the pipe (maybe an instrument box?) . Again, don't imagine that's going to be a nice clean cut. Can't imagine they'll be able to clamp anything to the pipe that will withstand the pressures and keep from slipping off. Plus, every time they run the saw, visibility goes to nil. Tough conditions to work under, as you say. But that flange looks like a good spot to attach something to. Gotta remember, even though they're working under tough conditions, they have a pretty wide open checkbook. Heck, they've probably got a room full of engineers that could have dwgs whipped up for something in an hour and the fabricators building it within two. (something with a big-a$$ ball valve in it. LOL)
I DO think that cutting the riser was the best approach. Trying to deal with a bent over, busted pipe was a nightmare, I'm sure. Also, anyone got any idea what kind of pressures they'll be dealing with when they reduce/stop the flow?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
