Posted by RobertTX on June 03, 2010 at 08:57:10 from (34.254.119.222):
In Reply to: Post hole digger posted by Gary Newkirk on June 03, 2010 at 06:53:32:
A post hole digger will work fine on your Ferg. Down pressure is not necessary. Sometimes in very hard dry soil you can pour water in the hole to soften. One thing to watch - as one guy said they can auger in like a corkscrew. This can happen in wet soil or if the auger gets under a root. Most people's response when this happens is to pull up on the lever to raise the three point. If it has a good bite, this will either raise the front of the tractor off the ground or bend the boom of the digger. The correct reaction is to disengage the PTO to stop the auger, then see waht is needed to get out of the hole. Sometimes it is necessary to reverse the PTO shaft with a pipe wrench when you have everything safely out of gear and stable.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
