Between pacific and hwy 100 washington exit, (5 miles) They are adding lanes. Pouring concrete at night. Dont know how the backups are dont drive to work anymore (retired).You can bypass it by getting off at the six flags exit and going under 44 to the south side of the interstate. That is old hwy route 66. It goes through a couple small towns, Pacific and Grey summit. Slower speed limit but moveing if the trafic is blocked up on 44. From six flags exit to 100 washington exit is close to 10 or 12 miles.AT hwy 100 you can get right back on 44. There is two big truck stops there.There is also a place just before you get to sullivan where you have to slow down to use a by pass where they are redoing a bridge. Pay att. to the slow down signs there. going to fast and you will tip over. sharp turn and off set drop for a interstate. hope this helps Sam
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
