Posted by Fred Martin on May 23, 2010 at 10:26:42 from (216.158.74.179):
In Reply to: Help!! posted by Allan In NE on May 23, 2010 at 04:30:20:
This post brings something to mind...bought a used Woods RM-59 finish mower and it could use new blades. Went to local place that sold generic stuff. They had the right size new blades for about five bucks apiece...but, they turned the wrong direction. Went to a dealer that sold Woods products....and they were forty five bucks for a set of three. The manufacturer made them run backwards so the generics wouldn't work, (read propietary) and with a left handed threaded bolt holding them on. I bought the new set and started mowing a place where it was awful rough on new blades. I know some don't approve of my next move but, I cut a piece about three inches long from a new push mower blade and welded it on in place of a cutting edge on the old blades...and sharpened it up and tried it. It shook the machine so, I took them off and static balanced them on a nail...after all, I was mowing where no one was near this supposedly dangerous rig (but me)and they hung right in there...I am not dead yet! But, I am what I consider a "good welder". I used eighth inch 7018 rod (DCR polarity)and one bead top and one bead bottom...they have held up for years. I don't recommend that everyone run out and do this cause it is dangerous...and someone could eventually get hurt or maybe killed...just wanted you to know it seems to be possible...IF you are a good welder WITH some good luck...and NO ONE is anyways near the mowing operation...AND you don't have new tires on your tractor...smile! You're on your own on this one. AND I'll get a lot of flak saying I probably shouldn't have even posted this. OR, have the post removed. I must be having a senior moment. Well, here I go getting my intelligence sized up. ohfred
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
