Posted by 1970-1655 on May 13, 2010 at 05:27:04 from (70.105.119.111):
In Reply to: Retiring posted by LarryD; on May 12, 2010 at 16:49:13:
Enjoy your retirement. I retired 2 years ago at age 58. I told my wife I was going to work until it was not fun any longer. A new plant manager with an attitude helped me decide. I have been busier after retirement than ever before. I have never thought about getting another job as I don't have the time for it.
One piece of advice I have seen over the years: Never run out of things to do, even the little things. Most that have done that sat down in the rocking chair and gave up. Life was over too soon after that. Ones we all knew would be gone soon after retiring are still kicking because they are so busy they do not have time to die. We need a reason to get up each morning or it's over.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
