Posted by Brad Gyde on May 09, 2010 at 18:30:56 from (68.28.138.229):
Ok.. so a few weeks ago there was a post about 12v conversions. I asked a few questions since when I converted My massey Harris to a 12v, it would charge, but if it sat the battery was always dead after 3 or 4 days.
I wired it as it said.. 3 wire delco
Battery terminal of alt to + side of ammeter (as the generator was)
Terminal 2 jumped to batt terminal of alternator
Terminal 1 to coil side of ign switch (with a small "idiot light" in line (one side of light to ground, other side to the wire)
Once started, the light DOES NOT go out as it was said it would (and yes, I revved it up.. ammeter shows a charge) If I turn the key off, the tractor continues to run, until I unhook the #1 terminal. If I leave it unhooked, the alternator does not excite. It said to use either a light, a resistor, or a diode, and that I didn't need to use any combination.. just any one would work fine
What have I done wrong?? I don't consider myself dumb about this sort of thing.. and I followed the directions, so why is it not working like it should?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
