If you do wheels with tires on them don't forget to use duct tape on valve stems sand will eat them up or if old can break them right off. Sand can clean tires right up if someone has gotten over spray on them from a older paint job. Lots of duct tape sometimes more than one layer to protect, paper, cardboard and plastic bags to protect things. Don't point the blast nozzle close or 90 degrees slant it more like 45 so sand cleans but bounces off and doesn't warp sheet metal and don't hold it close in one spot long trying to get it all off in one pass use several sweeping motions across and let the sand do the work not using higher air pressure that can cause damage and warp metal. Have the best moisture traps you can get on air compressor and drain them often and keep moisture out of the air tank blasting on a very humid day will cause lots of plugging problems in the blaster.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: Black Tire Paint - by Staff. I have been fortunate in that two of my tractors have had rear tires that were in great shape when I bought the tractor. My model "H" even had the old style fronts with plenty of tread. My "L" fronts were mismatched Sears Guardsman snow tires, which I promptly tossed. Well, although these tires were in good shape as far as tread was concerned, they looked real sad. All were flat, but new tubes fixed that. In addition to years and years of scuffing and fading, they had paint splattered on
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
