|
Tractor Talk Discussion Board |
Re: fuel pump recalibrating
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Diesel Dan on June 06, 2001 at 17:43:58 from (205.216.83.235):
In Reply to: fuel pump recalibrating posted by shannon on June 05, 2001 at 17:36:39:
Pull top cover,remove govenor spring guide stud, remove spring assembly,drain fuel from pump through side cover, rotate engine slowly by hand till an allen screw can be seen through the hole under where the spring was,use a 5/32" allen wrench and tighten the allen screw 1/8th turn for about a 10% fuel increase. Reverse procedure for reassembly. Sounds easy?
Any more free info can be costly, procede at your own risk. Have fun.
Diesel Dan the pump man.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
