Posted by John T on May 07, 2010 at 05:34:18 from (66.244.97.31):
In Reply to: Fact or Fiction?? posted by old on May 06, 2010 at 21:39:19:
"Statics" (as in Statics and Dynamics) is akin to Physics and well settled, proven and accepted. "Statistics" is a mathematical science thats also well settled HOWEVER its no more accurate then the data upon which it is based which may or may not be accurate. i.e. the science is fine its just that the answers are no more accurate then the data collection process and its integrity.
Ive also studied both and believe in both SUBJECT TO an understanding that goes sort of like the old saying "Figures dont lie, but liars figure" which pretty well answers Olds question.
John T (PS Being an Electrical Engineer, Statics and Dynamics, more of a Mechanical Engineering subject, wasnt my cup o tea)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.