Posted by JMOR on May 05, 2010 at 04:48:41 from (72.181.166.200):
In Reply to: coils posted by buickanddeere on May 04, 2010 at 05:54:27:
Leroy said: (quoted from post at 20:19:16 05/04/10) John T, does the coil have to be mounted to metal, grounded, on the tractor or engine or will it work if just hanging in midair like tied up with a string as in working on things and too hard to continue mount, take off and remount? Or to be remounted to a handier place but possibly mounted to like a piece of plastic that would not be a conductor?
I'm not John, Leroy, but no your coil does not need to be mounted to metal, all electrical windings inside are isolated from the housing. If it is heat that you are concerned with, not to worry, as when run hard on a warm day there isn't anything around the engine or attached to it that you can hold your hand on (unless your superman, 140 to 150 degrees is about all you can stay on). Set your coil on the work bench, connect to a power supply, set current to 3 amps and come back in 3 hours and pick up your coil,,,,it won't take you long to "feel" of the 200 degree can! Between the coil generated heat & the engine heat/surrounding heat, close to 200 is where it normally runs. It is designed for it, stop worrying.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
