|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Re: Synthetic Oil During Break-In ... A QUESTION !!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Burrhead on June 02, 2001 at 09:52:01 from (12.74.16.94):
In Reply to: Re: Re: Re: Re: Re: Synthetic Oil During Break-In ... A QUESTION !!! posted by Dean on June 02, 2001 at 07:14:01:
10-4. No sweat you're right. I was the one misunderstanding the direction. Along that same line on the oil grades. I inframe rebuilt a 400 Cummins in a neighbors grain truck years ago and he almost got us both killed for cussing the work because his Cummins used more oil after the rebuild, and my shoddy work. I took and oil sample and sent it off for analysis. He was using Haveline 10W30W in it and it was evaporating. When we switched it to Shell Rotella 30W he has'nt had a problem in over 300,000 miles now.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
