The reason for the 4' deep holes I would suspect is to get below the frost line so when the ground freezes it doesn't move your building around. But that is a minimum requirement. The actual size of the footing depends on the spacing of the poles and the type of soil the building is resting on. Are you building from scratch or did you buy the building as a kit from a manufacture. If you bought from a manufacture what do the plans show. Are they power poles or built up 2x6's? Green treat? When they put up my parent garage they put the post in the ground and put the concrete around to set them in place. I think they may have put a flat concrete block/paver at the bottom first to set and seal the post bottom. I don't think with a building you are going to be able to get away with just setting the post on top of the concrete or just half way down...not unless you want it to end up at the neighbor's in a gust of wind.
I would suspect the building contractors did a bigger hole to have more play in adjusting the posts. The layout and digging must be much more precise if you use a smaller hole.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
