Loader Hydraulics wimpy, why?

Posted by Rick from Paso on May 30, 2001 at 23:31:56 from (63.174.83.45):

I adapted a Cat2 bolt on 3 point and put a box scraper on my Case 310B, this works great. When I run the cylinder to its limit in either direction it will kill the engine running at idle. I assume this is because I have the relief valve pressure set too high. On the front end, the loader cylinders have a hard time lifting a full bucket of sand, even with the engine reved to governed speed, especially when the fluid gets hot. I hear the relief valve going pretty quick on the control valves for the loader. I was thinking that perhaps I need to increase the relief pressure on the loader valves. Any suggestions? Thanks for your help.

Regards, Rick from Paso.

Follow Ups:

• Re: Loader Hydraulics wimpy, why? Dave 06:45:21 05/31/01 (1)
  • Re: Re: Loader Hydraulics wimpy, why? Rick from Paso 00:50:38 06/01/01 (0)
• Re: Loader Hydraulics wimpy, why? paul 00:10:10 05/31/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Loader Hydraulics wimpy, why? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]