Posted by david from mo on April 23, 2010 at 16:59:55 from (72.35.163.7):
In Reply to: OT Dakota cv shaft posted by Tony S. on April 23, 2010 at 15:15:41:
REMOVAL Raise the vehicle. Remove wheel and tire assembly. Remove the skid plate, if equipped. Remove cotter pin, nut lock, and spring washer from the stub shaft . Remove hub nut and washer from the stub shaft . Remove brake caliper and rotor. Remove ABS wheel speed sensor if equipped. Remove hub bearing bolts and hub bearing from the knuckle (HUB/BEARING). Support half shaft at the C/V joint housings. Position two pry bars behind the inner C/V housing and disengage the C/V joint from the axle (HALF SHAFT). Remove half shaft from the vehicle. per dodge .david
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
