Allan In NE said: (quoted from post at 09:04:07 04/21/10) Gotta get in on this one as I notice that my handle is being bantered about a bit. :>)
A rear mount is by far and away faster, do a better job and WAY, WAY more accurate because of those large stabilizing discs that hold the cultivator locked on the row. The tractor can "wander around" and the cultivator stays put. Far more forgiving and ya don't have to "watch the row" nearly as much as you do with a front mount.
Somebody show me a front mount that will perfectly cultivate a short crop at 8 mph and I'll concede. :>)
(1)A stabilizing disk on a RM cult keeps from plowing/covering up crop. So are you stating that even with turning from side to side of frt wheels of tractor(which is normal if operator looks back) no crops will be affected because stabilizer wheel will hold cultivator to a point to keep dirt off of crop?
(2) With same type of rotary hoe,sweeps &/or fenders what in your opinion gives a RM the advantage over a FM to cultivate a short crop @ 8 MPH. Thanks,Jim
This post was edited by Tx Jim at 04:20:39 04/22/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
