Posted by Weldon K on April 20, 2010 at 18:29:26 from (98.16.29.45):
In Reply to: concrete mix posted by JOB on April 20, 2010 at 17:31:16:
#
# The proper mix of ingredients is determined by the intended use of the concrete.
# For foundations and retaining walls, use about 6-1/4 gallons of water for each sack of cement if the sand is damp. However, if the sand is wet, 5-1/2 gallons of water will easily do the job.
# Concrete that's mixed for pouring sidewalks, stepping stones, slabs, etc., requires about 5-3/4 gallons of water per sack of cement if the sand is damp and about 5 gallons if the sand is wet.
# If you are pouring heavy footings for walls where waterproofing is not a factor, mix the concrete with 1 part cement, 3 parts sand and 4 parts gravel.
# For sidewalks, steps, driveways, etc., use 1 part Portland cement, 2 parts sand and 3 parts gravel.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
