Bryan, since Watts = Volts x Amps (were talkin unity 1 Power factor here with a pure resistive load), 6 x 300 = 1800 total watts divided by 120 volts = 15 amps in the branch lighitng circuit.
If using 12 gauge conductors Id still (old engineering habit and practice) use an 80% max for a continuous load and 80% of 20 amps is 16 amps so YESSSSSSSSSSSS 12 Gauge wire will work.......(still somewhat subect to temperature and insulation and number of conductors in an enclosure etc etc etc)
While a 15 amp rated switch is rated to handle 15 amps, I never liked to design right up to the limit and usually applied an 80% factor, so I would prefer a switch rated at 20 amps OR ELSE use a lighting contactor (relay) and they even make circuit breakers suitable for switching use as I recall (been retired tooooooo long lol)
Id be comfortable with a 20 amp overcurrent protection device (circuit breaker or fuze) on a branch circuit of 12 gauge wire.
NOTE Incandescent arent very efficient (Lumens per watt) sure you dont want to consider at least Fluorescent (can use high efficiency ballast rated for cold temp starts ya know) lamps or even High Intensity Discharge (HID) lighting such as coated Metal Halide which yield a decent color rendition. Sure the initial cost is much higher butttttttttttt you get much longer lamp life and much lower electric utility cost
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
