#1 Pryolysis is the process of the tire-rubber being overheated and emitting explosive gasses. Not "warm to the touch." It has to be much hotter. Most pryo-tire explosion investigations have found tire rubber that had gotten so hot it had almost caught fire from a torch or welder. The misleading issue is - often the tire on the outside does not feel hot, so the hot-spot internally goes un-noticed.
#2 That explosive gas has to be trapped inside the tire.
#3 If there is enough heat present, a blast of oxygen has to hit it allow an explosion to take place - not much different than how a diesel engine works with a glow-plug.
#4. If there is NO heat anymore, nothing can happen without an external source of heat to ignite the mix. Thus my mention of a cigarette.
As to the story with the guy with the tire on his lap? Sounds like a normal blow-out to me - but no real facts are provided. If the tire had been over-inflated, it certainly could kill somebody at close range. I was in a shop where a guy got killed when he filled a tire - to what we think was 180 PSI. That was a "blow-out" and not a "tire-explosion." A blow-out only has the force of the PSI involved. A tire-explosion has igniting gasses involved and can easily exceed 1000 PSI.
The Bridgestone video, nor any other video has much use unless all the facts are provide. I've read many full-scale investigative reports of pyro-tire explosions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
