Tractor Talk Discussion Board |
Re: Re: Starting an old F-12
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on May 19, 2001 at 16:05:44 from (209.130.133.10):
In Reply to: Re: Starting an old F-12 posted by Shank on May 19, 2001 at 05:37:04:
I find I have to take the mag off the tractor to do the oiling and if your tractor hasn't run for a while you may want to do that before you hook all the wires. Once its off pull off the cap and look where the metal tab is so if you turn the mag by hand you will know where it was when you take it off. Inside the cap there are 4 carbon rods that run against the rotor. The carbon will smear over time and needs to be cleaned off. As part of my mag maintenance I take a pencil eraser and remove the carbon. If you need parts such as the carbon rods, points and condenser or rebuilding parts for your fuel pump, Rice Equipment in PA has everything you need.
Follow Ups:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|