Posted by Christos on March 23, 2010 at 05:02:39 from (130.108.192.93):
The fuel line from the sediment bowl assembly to the carburator (MF 135 Deluxe) was hacked up and spliced as well as now obsolete from AGCO/Massey.
I made one out of brake line at napa and had it cut and flared to length. I couldn"t get the end that screwed into the bowl assembly to bolt up so I took the bowl assembly to test fit it off the the tractor.
The hole the fuel line goes into are just a hair too small for it to fit and it won"t work. It fits perfectly at the carburator elbow end. I had a compression fitting and that didn"t seem to help either.
I"m using the 1/4" line you can get from NAPA...I can get my hands on a NOS part from Parts Depot, its just I don"t have the 40 bucks off hand to spend on it. Is there a trick to make what I have work until I get the NOS part?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
