Posted by JMOR on March 08, 2010 at 08:12:59 from (72.181.166.239):
In Reply to: Ratio of 2 cycle oil posted by showcrop on March 08, 2010 at 07:58:19:
If you search the archived posts on this subject, you can find any answer you want.........you know, everybody has one....an opinion, I mean.
Here is mine: I'm too tight to want to replace anything that I don't absolutely need to, so even if in some posters opinion 50:1 mix will be fine in my old Homelite saw which calls for 12 oz/gallon, or 10:1, I figure it has lived well on 10:1 for the last 50 years on that diet, so why experiment now. For everyone else, I say make your own decisions or bets. You do know they will even run for awhile on 100:0, don't you? :wink:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
