Re: Re: Re: Re: Re: Pressure Plate Pin

Posted by Al English on April 23, 2001 at 19:34:53 from (24.30.29.47):

In Reply to: Re: Re: Re: Re: Pressure Plate Pin posted by joe on April 23, 2001 at 18:49:44:

To release the spring pressure that's keeping you from installing that pin, the pressure ring in the pressure plate must be forced away from the flywheel face at a point adjacent to the release lever needing the pin. You probably have an open, three finger, "long" style pressure plate. If so, the practicality of doing this depends on the amount of room afforded by your flywheel housing and the tools you find or make to compress the clutch pressure ring. If you decide to give it a try be careful not to damage the clutch disc, or the friction surfaces on the pressure plate and flywheel. There are normally spacers/washers on either side of the release lever. If that's case with yours make sure they are in place when the pin is installed. If this can be done at all I see it being a two man job. And most of all, watch your fingers. Good luck...Al English

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Re: Re: Re: Re: Pressure Plate Pin Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]