You probably ought to ask this question in the Ferguson forum as you"s get more and quicker responses.
Was the fluid warmed up? In cold conditions it takes some time to warm up especially if ou are using the OEM recommended fluid. The colder the weather the longer the warm up. Acceptable leak down with an implement on the hitch is 15 minutes after the engine is turned off witht eh lift lever full up.
Failure to lift can becaused by a leaking lift cylinder, leaking supply tube, a sticking control valve or the control fork coming off the control valve "T" stem.
Failure to drop can becaused by a sticking control valve or a or the control fork coming off the control valve "T" stem or a misadjusted quadrant.
I would suggest you get the hydraulics warmed up and take off the right side access cover to the hydrauic compartment, engage the pto lever and start the engine(UNDER NO CIRCUMSTANCES PLACE YOUR HANDS INTO THE HYDRAULIC COMPARTMENT WITH THE ENGINE RUNNING!) Move the lift control lever to the full up position and observe the bottom of the control fork ("H" shaped part)moving the control valve forward. Look up at the lift cylinder to see if it"s leaking. A more than a few drops is a leak. Usng a flashlight and a mirror, look in the front right corner of the compartment for a vertical tube. Look for a leak there. Look at the pump side plates for leaks. Look at the base of the pump. Lots of turbulence and noise could men the relief valve is partially stuck open.
Now put the lever in the full down position and see if the control fork moves the valve backwards(you can"t observe the valve through the fluid but youcan see the control fork motion. Put the lever back full up and shut down the engine. Reach into the fluid and feel for the "T" stem on the control valve. It should be connected to the "legs" on control fork and the control valve stem should be full forward. See if you can push it further forward. If you can, The valve is sticking. Now pull it full back and see if there"s any sticking feeling. Do these checks systematically and report bak on what you find.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
