I lost my wedding ring one day hauling hay and assumed it came off when taking my glove off. I got a metal detector and looked at a few places I might have taken my gloves off. That day I had also swept the leftover hay that had fallen from the bales onto my trailer into a pile off the side of my trailer. A couple months later my wife was pulling a little hay from that pile for kindling to start a fire on a burn pile and found the ring. At the time I had never thought the ring was even in that area.
My wife had also lost her diamond when we were helping pick up items for a community garage sale and a ping pong table half fell on her gloved hand while loading it on the truck. She never looked at the ring, because she was more concerned with the pain on her finger. We talked to the owner a little while then left. She looked at her ring later and noticed the diamond was missing. We went back and found the diamond laying in the driveway where we had talked to the owner and apparently she had taken the glove off and the diamond had fallen out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
