Posted by Leyland-270 on February 27, 2010 at 08:28:47 from (75.253.87.144):
In Reply to: Welding VS Machining posted by Lanse on February 26, 2010 at 18:44:43:
I have done both. I now have my own shop. I would definitely do the machining program first. I did the same thing and took a college course during my junior year. I then went back my senior year for math and tech drawing night classes. After I graduated High School I spent one year working full time at a hardware store and went to college full time as well.
Didn't leave much time for a personal life or for getting in much trouble. I would also like to add that anyone that says you can train a monkey to weld is obviously a moron.
I have also had some formal training in welding as well. Welding properly is something that requires great skill and a steady hand. Allot of folks can stick a few pieces together but really have no clue what the right way is. A good machining program will have you do some welding as well. In repairing equipment being able to weld or knowing what to request from a weldor can make life allot easier.
At any rate to keep steady employment you must learn CNC. I did not and have paid for it in the long run. I do not mean just an operator either, but a programmer. If you are willing to move around a bit and live in a big city for a while you will do OK.
As far as welding goes you will want to learn to tig and to learn how to work with stainless would be your best bet. Tig is a cleaner environment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
