Posted by 135 Fan on February 26, 2010 at 20:45:28 from (68.149.56.30):
In Reply to: Welding VS Machining posted by Lanse on February 26, 2010 at 18:44:43:
Welding is heavy hard work and there is math involved. Welding is kind of hit and mis though. Shops can have poor ventilation and be very dirty and smokey. Lots of bending and lifting. You can be really busy then all of a sudden laid off. Machining is usually much cleaner. Running a robot might be neat but would get very boring. Probably a lot more to remember with machining but machining is usually done indoors, while welding can be indoors, outdoors, hot or cold or even underwater. Lots of standing doing machining and lots of crawling in around and over things with welding. Both can be good or bad but I'd probably try the machining route because it is a cleaner environment. The decision is up to you though. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
