Posted by Billy NY on February 25, 2010 at 04:04:01 from (74.67.3.238):
In Reply to: OT Drywall Question posted by super99 on February 24, 2010 at 14:22:37:
Ditto to what was said below, ideally, you should be running the heat, 60-65 F would be ideal, as would maintaining a temperature around that prior to and after each successive coat. When you are at that phase of the job, during cold weather, temp heat or having the buildings heating system commissioned and fired up and in use is a direct cost of the overall cost of the building.
Colder temps, the joint compound will take excessive time to dry, and could create minor problems, hard to comment on that, too many variables. I've been around a lot of jobs where trailer loads of drywall and joint compound were installed, high rises, commercial buildings etc. if in the winter time, heat was on consistently, no fluctuation.
I think keeping the substrate temperature within tolerance in advance of performing the work and after is important like was mentioned, it takes time to get things warmed up besides the air, I'd heat the area until done if were me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
