Posted by steve il on February 24, 2010 at 18:30:32 from (70.41.40.190):
In Reply to: IH 815 and 915 posted by old art on February 24, 2010 at 17:48:30:
Unclemerle said: (quoted from post at 02:48:30 02/25/10) I'm in the planning stage of a project and need a little info on these two models. 1: What was there rated HP? 2: Are they a true Hydro or do they go through a tranny run by a pump? 3: Value of one with a good engine, cab and running gear? Machine will be stripped down and built back up it so don't care about looks and condition of anything other than what I asked about.
TIA: Merle
engine is main value. 1500 to2500. they have 3 speed trans driven by hydro motor, supplied by pump on the engine. if you find one junked with good engine,lots of the time the hydro is weak. that will cost probably 1500 to 2000 to rebuild. not sure on hp 815 about 110, 915 probably 135
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Ferguson TO-20 - by Staff. When the infamous "Handshake Agreement" between Henry Ford and Harry Ferguson fell by the wayside (that's a story in itself), Harry Ferguson quickly set up manufacturing plants for a United States version of his English TE-20. The TO-20 was relatively the same as the TE-20 except utilized some different casting materials and had a US-style electrical system. The TO-20 was a dead ringer for the Ford 9N and 2N models and they say that Ferguson did this on purpose when the Handshake Agreement wen
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
