Posted by Leyland-270 on February 24, 2010 at 17:23:02 from (75.221.213.240):
In Reply to: OT Drywall Question posted by super99 on February 24, 2010 at 14:22:37:
I have been taping for 10 years and the most important thing is that the surface temp of the drywall is at least 55 deg. 65 is ideal. Crank the heat Friday and start on interior walls Saturday and leave exterior wall to last. You will find inside corners on exterior walls will take the longest to dry as they do not get the air flow that they need. Take a couple of box fans with you to help aid in drying. Also keep your mud and wall about the same temp. Tape will not stick to a cold surface say under 40 deg. If your mud is in the office building now it will take a few days to heat a five gallon bucket to its core. For the top coat add a 1/4 cup of dish soap to a five gallon bucket of mud. It is not technically five gallons of mud but goes by weight. Most buckets are actually less than 5 gallons. Good luck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
