Posted by Crem on February 23, 2010 at 17:57:17 from (174.42.241.175):
In Reply to: on the way posted by larry@stinescorner on February 23, 2010 at 15:44:13:
We used to haul our stock car on one like that only we had a 1951. The bed was pretty high and to load the car we had to use two sets of planks on each side with blocks in the middle to support the planks. Usually when we loaded and made the run up there and barely stopped at the end of the bed, all of the ramps would be laying on the ground. I remember one time after a wreck we had to run up the ramps without any clutch linkage. Now that was fun. We never thought anything about it, that was just part of the game. I wish that I could be that care free now. Another thing is that the 4 speeds in those trucks were non synchromesh so a person learned to double clutch pretty good after awhile.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Threshin Demonstration - by Michael Delaney. Introduction I bring you greetings from Prince Edward Island, Canada. We are Canada�s smallest province but big on farming. Maybe you�ve heard of us. Potatoes are our biggest crop. However, there is lots of mixed farming here also. I have a small mixed farm with 25-30 cattle. I make very good use of old machinery. I have a 135 MF Diesel, Farmall H and 1/3 share in an Allis B. I have complete lines of tillage and harvest equipment, and a saw gear etc. I have everything one would
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
