Posted by Owen Aaland on February 20, 2010 at 08:30:30 from (198.70.47.146):
In Reply to: IH 706 problems posted by Jeff-oh on February 18, 2010 at 20:56:19:
Leyland-270 said: (quoted from post at 11:46:23 02/19/10) I am guessing that your loader is operated from the tractor's remote services. A 706 does not have open center hydraulics. Not seeing it I can only conclude your hoe operates from the return side of the tractors services which is why you have to bungee a valve open to allow a flow of the charge pressure. With allot of use this will be a bit tough on your system. My hoe has an open center valve bank so I routed my flow through my hoe first then back to the tractor. I have also done this with loaders on tractor with a charge pressure, but your power steering will no longer have priority over the loader. Of course not an issue with the back hoe as you are not steering at the same time as using the hoe.
The 706 does indeed have an open center hydraulic system. It is also quite likely to have both front and rear outlets on the same auxiliary valve. It is possible that the hoe is connected to a rear outlet that also has the front outlet connected to the loader. Without more information of how the hydraulics are plumbed we are just making wild guesses.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.