Posted by Brian G. NY on February 19, 2010 at 11:45:20 from (72.10.202.182):
In Reply to: Electrical Grounding posted by John T on February 19, 2010 at 10:31:46:
When I ran 220V 100 amp service to my pole barn back in "96 I ran approx 220' of 3 wire 2-0 Aluminum in PVC conduit and believed I was "good to go". I used it this way until" '05 without any problems but by that time I had read many horror stories about not having a dedicated ground on outbuildings. I then bought enuf #4 copper to run a separate ground back to the main panel and separated the neutral and ground in the barn's sub-panel. Back then, the copper cost me just under $100; I lucked out on that! There has been enuf discussion on this and other sites to make a believer out of me. I have gained a better understanding of the difference between ground and neutral from postings such as John T's. Thank you!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
