Posted by jdemaris on February 15, 2010 at 10:50:41 from (72.171.0.138):
In Reply to: splitting tractor posted by CliffordPaul on February 15, 2010 at 10:01:33:
Everything TractorVet said is right-on, for a minimum of required equipment. I had to split many tractors on-site, when I was a on-the-road mechanic for Deere. Even had to split a few 4020s on dirt, in the barnyard, which isn't the best place to do one (jack on a plywood sheet).
275 is a pretty heavy tractor. If you do it yourself, doublecheck the front axle pivot is well locked with wood wedges/shims. Make two guide studs to put in place of engine-to-trans bolts (just cut the heads off some long bolts). They will help a lot with pulling apart and putting back together.
When times come to draw the two halves back into one, a come-along on each side works nicely for a slow steady joining. Just don't force anything - especially the input shafts into clutches.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
