As previously stated. Two sets of neutral to ground bonds a few feet apart in the meterbase/main switch or main distribution panel. Are close enough not to cause problems. Problems arise when the neutral is carrying current and has normal voltage drop all conductors suffer.When somebody goes and bonds it somewhere to ground and makes a path.For neutral current to now also flow on the ground system. Imagine now when some jackleg electrician plugs in a standby generator into a 240V welding receptacle and tries to push neutral current through the grounding system. The only path for neutral current can end up being from the building ground rods. Through earth and to the ground rods at the service transformer. Because the grounding system and earth are not perfect conductors. The grounded system is going to be "live" to some degree. Somewhere between 1 and 120V depending.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
