Posted by jm. on February 12, 2010 at 17:32:36 from (75.106.96.58):
In Reply to: Loader Speed (Dump) posted by Kirk Grau on February 12, 2010 at 06:55:49:
Kirk I did not dare to respond in the open. Too many know it all s on here. NO WAY changing the pump would help your dump time. THAT loader has built into the lower fitting on the bucket dump cylinders what we call an orfice. A small opening that only allows the fluid to come out at a reduced volumn. Ford did this (as other loadersdo) for a reason. So you would not just dump everything all at once. It also serves as a safety on the bucket tiping to fast.. You could go in and dril out but you want be satisfied..Best left alone but don,t go spending on pump..As the one guy sugest make SURE the down spol is moving to it,s limit sometimes the linkage will get worn..Hope this helps Jerry Watkins 731-707-0860
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
