Tractor Talk Discussion Board |
Re: hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on April 03, 2001 at 11:14:03 from (63.160.195.12):
In Reply to: hydraulics posted by jim on April 02, 2001 at 21:34:20:
Not enough information but will give it a shot. Does the hyd valve have a built in pressure relief valve? these valves squeal when they open. Get a pressure guage on the system to see where the pressure relief valve opens.Most new aftermarket valves are set for 1800-2000 psi, but some old tractor systems used a little as 1000psi. If the system pressure is at specs then you need to reduce pressure required by increasing cylinder size on the impliment.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|