Posted by Tx Jim on February 11, 2010 at 03:42:18 from (67.142.163.23):
In Reply to: Re: Chip Foose 4020 posted by J Heitkemper on February 09, 2010 at 16:18:28:
All-Powershift!! said: (quoted from post at 00:49:57 02/11/10) You sound like a brainwashed deere dealer salesman , who atended to many company salesman, training classes..the 6D series tractor are south of the boarder make, JUNK! I rented a 6130D for 2 days last fall to run silage chopper, my 4320 was down with pump & injecter repair; it has 12,000 hours on orginal sleves & pistons it is 3 times the tractor the 6130; little 4-276 engine
;
is 1/3 the tractor the 404 engine is in the 20 series! ... dealer offered it to me for 35% of cost, he's had it a long time, he said he like to trade it my 4020 or 4320 he could sell them tomorrow .. THAT'S my point..
Amen buddy,buickanddeere wants everybody to buy a New plastic JD to replace a dependable used tractor BUT WON'T BUY ONE HIMSELF!!!!!!!!!
My friend bought a new 6715 that my 4255 with 9800 hrs will out work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
