Ok, i'm looking at the illustrated. I figured the illustrated would be easier in this topic. What it says is you must have a Equipotential Plane over the area. It is a slab of concrete with wire mesh either embedded or under the concrete that puts the animal at the same electrical potential as the rest of the electrical system. The wire mesh is then bonded to the water trough also along with the pump being bonded (if it has a place to bond it to the rest of the system. The recepticle that feeds the pump must also be connected to a GFCI. Also according to NEC 250.6B you can make a grounding provision to prevent objectionable current by removing the grounding going to your water pump and installing a ground rod by your water pump and grounding it to that, and you must also make sure your water tank is also bonded to ground by using at least a #8 wire. I hope this helps. Also if you would like a nice isolation transformer here is where I used to get mine for installs http://www.altex.com/Tripp-Lite-2400-Watt-Line-Conditioner-AVR-System-LCR-2400-P139682C10753.aspx
This post was edited by TimMiller at 16:35:36 02/08/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
