Posted by CLTX on February 06, 2010 at 11:23:55 from (70.140.69.93):
I'm not trying to step on any toes, offend anyone or start a controversy, but I'd like to know the actual facts regarding the use of WD-40 to remove moisture in electrical systems. I read many years ago that WD-40 should never be used on electrical components such as ignition systems or electronics. I also was told the same thing by two different electronic technicians. Supposedly, one of the compounds used in the manufacture of WD-40 will eventually cause a breakdown in the insulation of the wiring. Prior to that time, I had used WD-40 on ignition system three times, and in each case, within a year, all electrical system wiring had to be replaced. A radio repairman and a radar technician both told me the same thing. All recommended LPS, among other things, as a good substitute.
My question is: Is there any validity in the above, and, if so, has the formulation have been changed? Is WD-40 getting a bum rap?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.